Six simple steps to get a smooth experience.


Clean and shave the desired area


Connect to power outlet and press the on/off button


Select the desired intensity level (1-5)


Place the device closely against the skin until the red sensor light starts flashing


Press the flash button, move the device to a new area, and press the flash button again.


Completed session! If you want you can add an aloe vera gel or moisturizer afterwards

The steps in detail


Clean & Shave

Start with cleaning and shaving the desired are that you want to treat. Do not wax or epilate before or between since it will remove the follicle.


Start Device

Press the on/off button for a second to start. When the green indicator lamp is lit, the device is ready be used.


Intensity Level & Mode

There are five intensity levels. Level 1 being the lowest, and 5 highest. We recommend starting low the first times and then increasing. There are two modes: manual and automatic (see below).


Place Device

Place the device against the skin. There is a built-in sensor in the device, that will make the red indicator light flash when the Mandy is correctly placed.


Activate Device

When the red indicator lamp flashes, the device can be activated by pressing the big flash button. After the flash, move the device and press the button again once the red light is flashing again.


After Treatment

After completed treatment, we recommend you to use a moisturizer or aloe vera gel to calm your skin.

Frequently asked questions

How often should I use my Mandy?

Step 1: Week 1-12

We recommend you to use your Mandy once a week the first 12 weeks.

Step 2: Once a month

After this period use your handset once a month, for 3 months or until satisfied.


To maintain hairless smooth skin, use your handset once every 2 to 3 months, or as needed.

Three modes:

Manual mode

Manual mode that activates the flash only when the button is pressed.

Automatic mode

The device will flash on its own once ready, without you pressing any buttons at all.

Glide mode

Will flash once the device is ready, as long you hold the trigger button down continuously.